Mistaway Pressure Tester

Mistaway Pressure Tester manufactured by Mistaway, is a replacement part for MistAway System Pressure Gauge.

Remove wear and tear guages with this easy to install Mistaway Pressure Tester to increase your misting system performance and achieve complete control over pests like mosquitos.

For best results, use Mistaway Pressure Tester when your gauge does not read "0" when the system is off and depressurized. Without replacing the current gauge with this product then you risk the efficiency of your MistAway Mosquito Misting Systems.

Tools Needed

To install the Mistaway Pressure Tester you will need to use a 15 mm wrench, channel lock pliers or crescent wrench, 5/16" nut driver and teflon tape.

How to Use

• Step 1: Remove the screws holding the controller and plastic cover of your MistAway Mosquito Misting System.
• Step 2: Expose the existing pressure gauge and then remove it from tubing using channel locks or crescent wrench from the female connector and nuts.
• Step 3: Wrap the teflon tape around the threads on the gauge and slide the new gauge on and tighten until secure.
• Step 4: Put back together the MistAway Misting Sytem Unit and then test the system to ensure there are no leaks and works at full capacity.

Where to Use

The Mistaway Pressure Tester is meant for the Gen 1.3 system.

When to Use

Use Mistaway Pressure Tester when your previous gauge experiences wear and tear. If your gauge reads "0" when the system is off and depressurized, then it is best to replace the pressure gauge with Mistaway Pressure Guage Replacement.

Safety Information

Mistaway Pressure Tester is safe to use around children or pets when applied according to the misting systems label. When handling any products it is best to wear the appropriate personal protective equipment (PPE) that will protect your eyes, mouth, face, hands, and feet.

Special Considerations

If the diameter of the failed gauge and the hole it was mounted in is the same size as the new Mistaway Pressure Tester you can proceed to step 3. If the new Mistaway Pressure Tester is not the same size then you will need to use adapter rings.